Removing internal code changes and activating previous change levels
Remove installed internal code changes and activate their previous change levels
to make the previous levels operational.
Remove internal code changes
only if it is necessary to resolve a problem
that occurred after installing and activating the changes.
| Important: |
Instructions for removing internal code changes
and activating their previous change levels
will vary with the set of changes you want to remove,
whether you want to activate the previous levels immediately,
and how you want to activate them.
Each example below provides instructions for a particular situation.
Your situation may be different;
refer to the instructions for general guidance.
Then, while performing the task,
request help for any window while it displays
for more information about using it to complete the task. |
Example 1
The following example shows the steps for:
-
Removing all installed internal code changes.
-
Activating their previous change levels immediately and concurrently.
From the Hardware Management Console Workplace:
-
Select the target CPCs or CPC group, and
start the task:
Change Internal Code.
This opens the
Change Internal Code
window.
From the Change Internal Code window:
-
Select
Remove and activate changes,
then select OK.
This opens the
Request Selection
window.
From the Request Selection window:
-
Select Do all concurrent changes only,
then select Remove and activate.
This
opens the Confirm the Action window.
From the Confirm the Action window:
-
Select Remove and activate concurrently to
begin the process.
This opens the
Change Internal Code Progress
window.
From the Change Internal Code Progress window:
-
Wait until
the window indicates the process is complete,
then select OK to close the window.
This completes the task.
Example 2
The following example shows the steps for:
-
Removing all installed internal code changes.
-
Activating its previous change level immediately and disruptively.
From the Hardware Management Console Workplace:
-
Select the target CPCs or CPC group, and
start the task:
Change Internal Code.
This opens the
Change Internal Code
window.
From the Change Internal Code window:
-
Select
Remove and activate changes,
then select OK.
This opens the
Request Selection
window.
From the Request Selection window:
-
Select Do all changes even if they are disruptive,
then select Remove and activate.
This
opens the Confirm this Disruptive Action window.
From the Confirm this Disruptive Action window:
-
Select Remove and activate disruptively to
begin the process.
This opens the
Change Internal Code Progress
window.
From the Change Internal Code Progress window:
-
Wait until
the window indicates the process is complete,
then select OK to close the window.
This completes the task.